3
PRE-INSTALLATION INSTRUCTIONS FOR DEALERS
The manufacturer has preset the water treatment unit’s sequence of cycles, cycle times, salt dose, exchange capacity and
salt dose refill time .
The dealer
should read this page and guide the installer regarding hardness, day override, time of regeneration,
service alarm and buzzer alarm settings before installation.
For the installer
, the following must be used:
• Program Installer Settings: Time of Day and Hardness (manufacturer has set system to Immediate Regeneration;
see Operating Displays and Instructions for more details), Service Alarms and Buzzer Alarm (optional displays
only available on the Sanitizer Plus models)
• Read Normal Operating Displays
• Set Time of Day
• Read Power Loss & Error Display
• Be sure system and installation are in compliance with all state and local laws and regulations .
For the homeowner
, please read Programming Procedures and Operating Displays and Instructions .
WATER SOFTENERS:
During operation, the normal user display is
time of day
and
gallons per minute
.
Flow Rate, Capacity Remaining
and
Days to a Regeneration
are optional displays but are not normally used . Each of
these can be viewed by pressing
NEXT
to scroll through them . When stepping through any programming, if no buttons are
pressed within 5 minutes, the display returns to a normal user display . Any changes made prior to the 5 minute time out
are incorporated . To quickly exit any Programming, Installer Settings, etc ., press
SET
CLOCK
. Any changes made prior to
the exit are incorporated .
Summary of Contents for Impression Plus IMP-1044TW
Page 22: ...22 REPLACEMENT PARTS...
