6
7
INSTALLATION
9 .
SAFETY BRINE TANK CONNECTION:
Install the 3/8” O .D . polyethylene tube from the Refill Elbow to the
Brine Safety Float valve in the brine tank .
10 .
OVERFLOW LINE CONNECTION:
An overflow drain line is recommended where a brine overflow could
damage furnishings or the building structure.
Your softener is equipped with a brine tank safety float which
greatly reduces the chance of an accidental brine overflow . In the event of a malfunction, however, an
overflow
line connection
will direct the “overflow” to the drain instead of spilling on the floor where it could cause
considerable damage . This fitting is an elbow on the side of the brine tank . Attach a length of 1/2” I .D . tubing
to fitting and run to drain . Do not elevate overflow line higher than 3” below bottom of overflow fitting . Do not
“tie” this tube into the drain line of the control valve . Overflow line must be a direct, separate line from overflow
fitting to drain, sewer, or tub . Allow an air gap as per the drain line instructions .
Connection at Refi ll Elbow on the control valve
Connection at Brine Safety Float in brine tank
Summary of Contents for Impression Plus IMP-1044TW
Page 22: ...22 REPLACEMENT PARTS...
