12
SOFTWARE VERSION
XXX
xx
TOTAL GALLONS
0
X1K
TOTAL DAYS
970
TOTAL REGENS
190
1
ERROR LOG 6146
101
1
4
6
TOTAL BRINE ERRORS
1
5
2
3
Second Level History Screens
Accessed by pressing
+
and
–
simultaneously for three seconds.
Once screen changes, press
+
and
–
simultaneously again for three seconds.
Non-resettable history.
Displays software version
Displays total gallons used by
Meter 1 since startup
Displays total days unit has been
in service
Displays total regens since startup
Displays last ten valve errors that occurred
Scroll through with
+
or
–
buttons.
A four digit number in the upper right corner of the
display indicates the motor position during the time
of error for logged drive errors.
Displays last ten valve errors that occurred
Scroll through with
+
or
–
buttons.
Error Code
Error Code Description
101
UNABLE TO START:
Valve not sensing valve movement with motor energized.
102
MOTOR STALLED:
Valve unable to find next cycle position (stalled).
103
MOTOR RAN TOO LONG:
Valve unable to find next cycle position.
104
VALVE HOMING:
Valve unable to find Home position.
106
MAV 1 RAN TOO LONG:
MAV 1 motor ran too long. Unable to find proper park position.
107
MAV 1 STALLED:
MAV 1 motor ran too short. Unable to find proper park position (stalled).
109
INVALID MOTOR STATE:
Control can no longer operate properly due to detection of an invalid motor state.
116
MAV 2 RAN TOO LONG:
MAV 2 motor ran too long. Unable to find proper park position.
117
MAV 2 STALLED:
MAV 2 motor ran too short (stalled). Unable to find proper park position.
201
INVALID REGEN STEP:
Control can no longer operate properly due to detection of an invalid
regeneration cycle step. Internal software issue.
204
LEAK DETECTED
402
POWER DOWN MEMORY:
Check sum error for operational data and status section of EEPROM memory
- specific type of memory error.
403
PROGRAM MEMORY:
Check sum error for programming section of EEPROM memory
- specific type of memory error.
404
DIAGNOSTIC MEMORY:
Check sum error for diagnostic section of EEPROM memory
- specific type of memory error.
405
HISTORY MEMORY:
Check sum error for history section of EEPROM memory
- specific type of memory error.
406
CONTACT MEMORY:
Check sum error for contact screen section of EEPROM memory
- specific type of memory error.
407
STATUS RAM MEMORY
FAILURE:
Control can no longer operate properly due to corrupted data detected in the Operational Data and Status Section
of RAM memory. Once generated, the Error Mode is not entered nor an error displayed, instead previously stored
data (<6 hours old) is used to maintain control operation.
408
DIAGNOSTIC RAM
MEMORY FAILURE:
Control can no longer operate properly due to corrupted data detected in the Operational Data and Status Section
of RAM memory. Once generated, the Error Mode is not entered nor an error displayed, instead previously stored
data (<6 hours old) is used to maintain control operation.
410
CONFIG DOWNLOAD:
Configuration file downloaded to the control was not originally uploaded from
another control with the identical software revision.
Error Codes and Descriptions
REMINDER:
Press and hold
NEXT
and
REGEN
for three seconds to perform a soft reset and clear an error on screen.
return to
general display
Summary of Contents for Sanitizer Plus
Page 1: ...Master Programming Manual for Sanitizer Plus Models Effective February 2019...
Page 13: ...13 Notes...
Page 14: ...14 Notes...
Page 15: ...15 Notes...
