Water Right Sanitizer Plus, Master Programming Manual

9

cont’d 

0:30

MIN

RELAY 1 TRIGGER

SET

REGEN 

RELAY 1 TRIGGER

SET

ERROR

RELAY 1 SETPOINT

SET

25

GAL

RELAY 1 DURATION

SET

RELAY 1 SETPOINT

SET

1.00

PPG

RELAY 1 TRIGGER

SET

PULSE

RELAY 1 TRIGGER

SET

FLOW

Configuration Screens  

Accessed by pressing and holding 

NEXT

 and 

–

 simultaneously for three seconds. 

Once screen changes, press and hold 

NEXT

 and 

–

simultaneously again for three seconds.

Set relay trigger with + or — buttons

REGEN GALLONS indicates that relay will be energized after a specified number of gal

-

lons are expended during service and regen. To set by this, press 

NEXT

.

Set relay trigger with + or — buttons

ERROR indicates that relay will be energized while unit is in an error mode. To set by 

this, press 

NEXT

.

Set relay trigger with + or — buttons

FLOW indicates that relay will close whenever flow is detected by the control. To set by 

this, press 

NEXT

.

Set relay trigger with + or — buttons

PULSE indicates that relay will generate a dry-contact signal output. To set by this, 

press 

NEXT

.

Set relay setpoint with + or — buttons

This is the gallons that will be expended before relay will 

initially energize.

Set relay setpoint with + or — buttons

Set meter pulses per gallon (PPG). Adjustable 

from 0.10, 0.25, 0.50, 0.75, and 1.00 – 10.00 in 1 

PPG increments.

Set relay duration with + or — buttons

This is the duration of time, after relay setpoint, that relay 

will remain energized. Adjustable from 1 sec to 500 min.

return to  

general display

return to  

general display

return to  

general display

continued from 

previous page

return to  

general display