WARNING:
Never put the Pool Blaster in water while the charging jack is connected.
WARNING:
To keep water out of the motor box, before submerging make sure the
On/Off knob is fully secured by turning all the way until it stops at a 12 o’clock position.
Once your Pool Blaster is set-up for use, you may put it in your pool or spa.
•
Bring your Pool Blaster to the side of the Pool or Spa and turn it on by turning the
On-Off knob all the way to the “On” position. This must be done outside of the
water before it is submerged.
•
Once the Pool Blaster is “On” it can be completely submerged in water and is
ready for use.
•
This appliance is designed to be in water only when in the “ON” position and has
battery power. Excessive leaking can occur when not running and void the warranty.
Never leave your Pool Blaster in the water when it is off.
WARNING:
If any parts are missing, do not operate until the missing parts are
replaced. Failure to do so could result in serious injury.
NOTE:
There are two ways to remove the unit from the pool:
1.
WHEN USING HANDLE: Lift from pool with the nose facing up to allow the water to
escape from the back and sides.
2. WHEN USING A VACUUM POLE: Remove the unit from the pool with the bottom
facing upwards and the handle facing down. This will allow the water to escape and
keep the dirt inside
NOTE:
The cleaner is only designed to vacuum water and will not vacuum air. The
cleaner will only work when completely submerged in water and the air is out of the
clear funnel.
WARNING:
Opening the “ON-OFF” knob exposes the motor components, never
let water enter the hole as this will ruin your appliance and void the warranty.
Cleaning the reusable filter bag
For maximum cleaning efficiency the filter bag/seal ring should be checked, emptied, and
cleaned after each use or whenever you notice the performance of you Pool Blaster declining.
To clean the filter bag/seal ring
•
Unplug the Pool Blaster from the charging outlet before changing the filter or
performing any other routine maintenance.
•
Place the Pool Blaster on its end (remove the vacuum pole, if attached).
•
Unlatch the upper and lower latch together (see diagram).
•
Remove the filter bag/seal ring by pulling it out of the funnel (see diagram).
•
Invert the filter bag/seal ring and rinse with a garden hose or in a sink. Note: do not
clean in a washing machine or with detergent.
•
Re-insert the filter bag when finished.
•
Note: Your reusable filter bag should be replaced if the seal ring is worn or if the
bag is torn
.
WARNING:
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
WARNING:
When servicing user serviceable parts, use only identi-
cal Water Tech replacement parts. Use of any other parts may create a
hazard or cause product damage.
HOW TO USE YOUR POOL BLASTER
WARNING:
Using your Pool
Blaster without the filter bag/seal
ring in place will VOID your war-
ranty.
