SOME DO'S
1. Do comply with all local plumbing and electrical codes.
2. Do install pressure-reducing valve if inlet pressure exceeds 90 psi.
3. Do install gravity drain on cabinet. See figure 7.
4. Do secure drain line on appliance and at drain outlet. See figure 3.
5. Do allow a minimum of 8 to 10 feet of 3/4” pipe from the outlet of the water filter
to the inlet of the water heater. See figure 1.
SOME DON’TS
1. Do not install if checklist items are not satisfactory.
2. Do not install if incoming or outlet piping water temperature exceeds
120 degrees Fahrenheit, 80 degree Fahrenheit for 97WB-IF.
Please see specification on page 27.
3. Do not allow soldering torch heat to be transferred to valve components or
plastic parts.
4. Do not overtighten plastic fittings.
5. Do not plumb appliance right up against a wall which would deny access to
plumbing. See figure 1.
6. Do not install the appliance backwards. Follow arrows on inlet/outlet.
See figure 2.
7. Do not plug the transformer into an outlet that is activated by an on/off switch.
See figure 8.
8. Do not connect the drain and the overflow (gravity drain) together.
See figure 1.
When calling the HelpLine, please have this guide and the serial number available.
From 8 am to 5 pm EST, call 1-800-437-8993. Your serial number may be found on
top of your valve assembly (See figures 2-3.)
4
Do
s
And Don ts
