Waterco Admiral Ultra, Installation Operation User Manual

REMoVING tHE cLEaNER FRoM tHE PooL

n

Slowly pull the Admiral Ultra’s blue power cord to retrieve the cleaner to the water surface and pool edge. 

  (DO NOT PULL THE CLEANER OUT OF THE POOL BY THE BLUE POWER CORD).

n

Reach down and grasp the handle of the Admiral Ultra and remove it from the pool as shown in Fig 1 and Fig 2.

Note:

 The unit should be stored in an area that will afford some protection from the elements to insure that it retains its finish.

cLEaNING tHE RobotIc PooL cLEaNER’S FILtER baG

Note:

 It Is Strongly Recommended That The Admiral Ultra’s Filter Bag Should Be Cleaned After Every Use.

n

Turn the Admiral Ultra upside down and place on the ground or stable surface so the bottom lid is exposed.

n

Press the two red tabs inward towards the centre of the Admiral Ultra as shown in Figure 3. Lift the cleaner’s bottom lid with the filter bag 

  up and out of the cleaner.

n

Grip the bottom lid of the Admiral Ultra firmly, with one hand and use your other hand to grab the filter bag material and pull it away from 

  and up from the bottom lid of the cleaner. Remove all large debris from the filter bag. Refer Figure 4.

n

Turn filter bag inside out and hose out all remaining debris as shown in Figure 5. If filter bag is very dirty it may be washed in a 

  washing machine. 

Note:

 When using a washing machine it is recommended to turn the filter bag inside out and wash using cold water (only) and a mild detergent 

without any other item within the wash.

Note:

 Do NOT use a clothes dryer.

n

Hose all debris out of the Admiral Ultra’s bottom lid being sure to remove all dirt from the fine filters situated on the intake doors as 

  shown in Figure 6.

5

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

Figure 6