Waterco Admiral Ultra, Installation Operation User Manual

n

To reinstall the Admiral Ultra filter bag, first place Cleaner bottom lid facing 

  up wards. 

n

Place the Admiral Ultra’s filter bag outer frame onto the Cleaner bottom lid and 

  ensure the filter bag frame seats fully into the retaining channels.

Note:

 Visually ensure the Admiral Ultra’s filter bag is correctly seated into cleaners

  bottom lid retaining channels particularly the corners. Refer Figure 7.

n

Once the filter bag frame is correctly positioned into the Admiral Ultra’s bottom lid 

  retaining the filter bag is complete.

n

Pick up the Admiral Ultra’s bottom lid and turn it over so the bag hangs down wards. Refit the cleaner’s bottom lid back into the cleaner 

  being careful to feed the cleaners filter bag back into the body of the cleaner.

n

Once the Admiral Ultra’s bottom lid is seated press it firmly into the cleaner. Gently pull on the cleaner bottom lid to insure that it is properly 

  locked in. The cleaner’s bottom lid is now correctly installed.

Note: Ensure the Admiral Ultra’s filter bag is completely enclosed within the cleaner housing as the bottom lid will not close properly, and the 
cleaner will not operate.

bLUE PoWER coRD MaINtENaNcE

In the course of using your Admiral Ultra, the blue power cord may become twisted or tangled.

the admiral Ultra blue Power Kink Resistant cord advantage

The Admiral Ultra Robotic Pool Cleaner has a specifically designed blue power kink resistant cord using a one piece extruded technology that 
prevents the cord from delaminating, protecting the internal wires from shorting out and extending it’s operating life.

If you refer to the blue power cord (Fig 8 below), there are no layers as the cable & wires are manufactured simultaneously. 
The coating of the cable is injected with air to form small pockets that allow it to float, so the outer layer takes the place of (3) layers 
of a typical cable.

6

Figure 7

admiral Ultra Robotic cleaner cable

Foam casing

air Pockets

(Enlarged in diagram)

Wire Inner core

(+/- coated in non-conductive material)

Fig 8