Section 10 – Warranty
42
Section 10. – Warranty
Warranty Terms and Conditions
PLEASE READ
1. These terms and conditions carefully, as failure to comply may affect your legal rights under this
warranty; and
Any installation and operation instructions carefully before commencing use of any product
manufactured by Waterco Limited (“Waterco”).
2. Waterco manufactures quality pool and spa products to the highest standards using the most
advanced technology and production procedures available.
WARRANTY COVER
If a defect occurs in any Waterco product, Waterco will at its discretion, repair the product or replace and
install the defective part, free of charge provided that the defect results solely from poor workmanship
or materials and subject to these terms and conditions.
Labour is covered by this warranty for a period of 12 months from the date of purchase or installation,
within a 25 km radius of an authorized Waterco Service Agent.
The purchaser is responsible for any freight incurred.
WARRANTY PERIOD
All products sold by Waterco are covered by a one year warranty. The exceptions to this are the
products listed in the schedule (which also specifies relevant warranty periods). All warranty periods
commence on the date of purchase by the end user.
The provisions of this warranty are not transferable and are in addition to and not in modification of or
subtraction from any applicable statutory warranties, rights or remedies.
CONDITIONS OF WARRANTY
This warranty only applies where:
1. The products have been installed and operated in accordance with written instructions supplied by
Waterco;
2. The purchaser is able to provide proof of purchase that specifies the date of purchase;
3. The product has been serviced or maintained regularly. (at least once a month).
Any pool and spa equipment has been used in water:
1. With a temperature not exceeding 40 degrees Celsius;
2. With a pH range maintained between 7.2 – 7.6;
3. That has been chemically balanced in accordance with the Langelier saturation index within a range of -
0.2 to + 0.2 to ensure that it is not corrosive or scale forming;
4. That is not salt water (other than mild saline water conditions which are compatible with swimming
pool salt water chlorination systems) – unless otherwise stated by Waterco in both the respective
product labels and brochures that it is suitable for seawater applications; and
5. That has been regularly treated with a sanitizing system using bromine, chlorine in one of its
compound forms, or generated in-situ, in concentrations (doses) recommended by the relative
state or territory health departments. (In areas outside of Australia please refer to the local health
department recommendations before use);
