DO NOT DEPRIVE HEATER OF WATER FLOW FOR MORE THAN 24 HOURS WITHOUT DRAINING IT. Make
sure you leave the bypass valves open as shown in figure 1.
At the beginning of each season you must properly balance your water according to the standards prescribed on
the previous page
BEFORE
circulating water inside the heat pump.
At the end of each season, if the heater is no longer used, and proper pool water chemistry is not maintained, it
should be disconnected from the water line and drained to prevent any possible corrosion.
All electrical connections must be done by a qualified electrician, according to the local electrical codes. Always
cut off the unit’s main power whenever the access panel is open or removed. Always install the machine outdoors
(unless approved by the manufacturer), while respecting the minimal clearances needed for proper operation and
heating.
PROPER POOL CHEMISTRY IS VITAL TO THE LIFE OF YOUR HEATER. PAY PARTICULAR ATTENTION TO THE
TOTAL ALKALINITY AND TOTAL DISSOLVED SOLIDS
. IT IS HIGHLY RECOMMENDED THAT YOU HAVE YOUR
POOL CHEMISTRY CHECKED OFTEN BY AN OUTSIDE INDEPENDENT POOL STORE.
I
pg 05
Heat Pump Swimming Pool Heaters
Water quality standards that must be strictly adhered to:
WARNING
!
IMPORTANT
MAKE SURE THE INSTALLATION WAS DONE ACCORDING TO THE INSTRUCTIONS OF THIS MANUAL.
SEE “INSTALLATION” SECTION.
MAKE SURE YOUR HEATER WAS PROPERLY GROUNDED AND BONDED. SEE “BONDING” AND “BONDING
DIAGRAM” SECTIONS.
READ YOUR WARRANTY ON PAGE 23.
!
VITAL
DESCRIPTION
NORMAL RANGE*
VERIFY
PH Level
Chlorine Concentration
Total Alkalinity
Total Dissolved Solids
Calcium Hardness
7.4 to 7.8
1.0 to 4.0 PPM
100 to 120 PPM
below 1800 PPM
Reg. Pool
below 3500 PPM
Salt. Pool
200 to 300 PPM
1 / week
1 / 2-3 days
1 / 2-3 weeks
1 / month
1 / month
1 / month
COMPONENTS DESCRIPTION
1. Heat Control
2. Evaporator
3. Cabinet
4. Fan and Motor
5. Heat Exchanger
6. Compressor
1
2
3
4
5
6
Inside the heater
Inside the heater
