Waterco Britestream leD light MK5
c) Drill 4 holes wih a 1/8” drill using the gland plate holes as a drilling
guide. Apply a small amount of Silicone Sealant on the screws and
drive into predrilled holes.
d) Screw wall bracket to the wall and seal screws.
e) Wind cord loosely around back of light catching it in clips.
f) Insert gland nut, rubber washer and then plastic seal ring onto the
power cord and feed the power cord through the gland plate.
g) Tighten gland nut onto gland plate.
h) Fit light to Wall Bracket by sliding the light downwards until the clip
and hook engage. Fix with screw at top.
FAULT
POSSIBLE CAUSE
REMEDY
Light not operating
- Fuse in transformer blown.
- No power to transformer.
- Fault in electrical wiring.
- Replace fuse.
- Check main fuses in switchboard.
- Electrician to check.
Light very dim and
pulsating
- Mismatch of lamp and
transformer ratings.
- Damaged wiring/ connectors.
- Fit correctly rated transformer*.
- Replace wiring/ connectors.
Main house fuse blows
when light switched on
- Faulty transformer
- Damaged cable
- Incorrect electrical installation.
- Call electrician to check
installation.
GLAND
PL
AT
E
Figure 2
GENERAL SAFETY RULES
1. The installation of the Waterco LED Pool Light should be carried out in accordance to the safety
instructions of swimming pools especially Standard HD 60364-7-702:2010, Install & protection output
circuit in accordance with AS/NZS61558.2.6, AS/NZS 3000:2007 or as amended and the specific
instructions for each facility.
2. The rules enforced on accident prevention should be carefully followed.
3. Any modification of the Waterco LED Pool Light requires the prior consent of the manufacturer.
4. Original replacement parts and accessories authorized by the manufacturer ensure a high level of safety.
5. The manufacturer accepts no liability for the damage and injuries caused by unauthorised replacement
parts and accessories.
6. During operation, some parts of the Waterco LED Pool Light are subject to dangerous electric voltage.
7. Work may only be performed on the Waterco LED Pool Light or on the equipment connected to it after
disconnecting from the mains power.
8. The user should make sure that assembly and maintenance tasks are carried out by qualified authorised
persons and that these persons have first carefully read the owner manual.
9. The operating safety of the Waterco LED Pool Light is only guaranteed if the owner manual instructions
are correctly followed.
10. In the event of defective operation or fault, contact the manufacturer’s Technical Support Department or
its nearest Authorised Agent.
11. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person.
12. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
WARRANTY
BriteStream LED lights are covered by a comprehensive 2 years warranty. Please refer to the Waterco
Warranty Booklet for further details.