GENERAL SAFETY INSTRUCTIONS
DO NOT DEPRIVE YOUR POOL HEAT PUMP OF WATER FLOW FOR MORE THAN
24 HOURS WITHOUT DRAINING IT. Make sure you leave the bypass valves as
shown in Figure 1.
At the end of each season, when the pool heat pump is no longer in use, and proper
pool water chemistry is not maintained, it should be disconnected from the water line and
drained to prevent any possible corrosion or damage to the pool heat pump. Refer to Figure
1 below or interizing procedure (page 21).
INSTALLATION INSTRUCTIONS
Location
In order to gain maximum efficiency please follow the instructions when deciding where to
position your pool heat pump. It is also important to allow clearances for future service and
maintenance procedures.
The unit is designed for outdoor installation and should not be installed in a totally enclosed
area such as a shed, garage, etc., unless ventilation is provided to ensure adequate
air exchange for proper operation. Re-circulation of cold discharged air back into the
evaporator coil will greatly reduce unit’s heating capacity and efficiency.
Pool heat pump
Pool heat pump
OUT
IN
OUT
IN
When your valves position are as
shown on Figure 1, the water is
bypassing the pool heat pump.
Figure 1
When your valves position are as
shown on Figure 2, the water is going
through the pool heat pump.
Figure 2
The valves shown above may be different to the ones installed on your system.
Please ensure you understand how your bypass valve operates.
