4
zu verschieben, bzw. zu beschädigen. Die
Länge der Schrauben (M3x 16mm) ist so
bemessen, das die VRM Backplate des
Originalkühlers weiterverwendet werden kann.
Die Schrauben dürfen nur handfest
angezogen werden um die empfindlichen
Spannungswandler nicht zu beschädigen.
4. Montage des Chipsatz Kühlers
Überprüfen Sie zuerst die Kompatibilität des
Kühlkörpers in dem Sie diesen an die dafür
vorgesehene
Stelle
halten.
Passt
der
Kühlkörper liegt keine verdeckte Revisions-
änderung des Mainboards vor und die
Montage kann durchgeführt werden.
Als erstes muss der Chipsatz mit einem
Wärmeleitmittel
versehen
werden.
Dazu
befindet sich ein quadratisches Wärmeleitpad
The screws may only be pulled hand-tight.
Overtightening can damage the voltage
regulators.
4. Mounting the chipset cooler
First, place the cooler at its intended position. If
the cooler does not fit, there might have been
undocumented changes on your revision of the
mainboard. If it does fit you can proceed with
the mounting:
Place the square thermal pad on the chipset
(PCH; which sometimes gets erroneously
called “southbridge”). Do not forget to remove
the protective film form both sides of the pad.