8
Installation/Removal After Completing Initial Setup
Tools Required: none
Once your WAG Boarding Steps have been properly fitted for your boat, installation, removal and storage are simple and
require no tools.
Always inspect equipment and boat for damage or loose fasteners prior to use.
Correct as necessary.
Installation
from the storage and transport configuration:
Figure 10
Figure 11
Step 2
- Remove the two (2) 1/2" detent ring pins, unfold the steps
by spreading the ends, and insert the pins through the 1/2" holes
adjacent to the 1/2" pivot pins. (Figure 11)
Tip: Keep pin rings
around fingers while handling to avoid losing the pins.
Caution: Do
not twist or torque the assembly during Steps 2 and 3.
Step 1
- Remove the folded assembly from its packaging, stand on end with the
hooks down, unhook the retention cord and let hang to the side. (Figure 10)
Caution:
Maintain a secure grip on the stretched retention cord when unhooking
and slowly relax the tension to avoid injury.