Installation of the filter system
How to Use the Quick-Connect Fittings (To connect)
If the tubing is not fully inserted, no seal will be created, and leakage will occur.
When the tubing is fully inserted, put the blue lock clip on the fitting. It will lock the tubing in
place and prevent it from falling off.
Step 1
Mount the Bracket
1. Make sure the arrows on the filter head are consistent with the direction of your water flow.
Unscrew four screws on the filter head then align the holes on the bracket with the holes in the
filter head. Insert four mounting screws included with the system through the bracket and into
the filter head until tight.
(Figure 1)
2. Choose a suitable installation position in advance. It can be put on the ground of cabinet or
fixed on one side of cabinet with a bracket.
3. Paste the assistant label to finish drill. Insert two screws in the hole.
(Figure 2)
Step 2
Install the Feed Water Adapter (cold water only)
1. Shut off the water supply. Turn on the kitchen faucet to release the water pressure
;
Note:
Make sure the water has stopped running before proceeding to the next step. Get
a towel or bucket to catch water.
2. Disconnect the cold water pipe from the cold water supply valve;
3. Twist the feed water adapter onto the cold water supply valve (with its washer) and tighten it
with an adjustable wrench;
Note:
If the cold water pipe is 1/2", unscrew the two converters from the feed water adapter
firstly (Figure 3), then implement step 3.
4. Twist the cold water pipe (with its washer) onto the feed water adapter and tighten with an
adjustable wrench.
Step 3
Install the Faucet
(Figure 4)
Note:
If there is no hole in your kitchen sink or countertop,you have to drill one (1") or use the
hole from the soap dispenser.
1. Insert the faucet spout into the faucet body;
2. Insert the faucet stem into the hole on the countertop;
3. Under the sink, slip on other parts in the order shown in the picture;
4. Insert the quick-connect fitting onto the faucet stem fully and firmly.
3/8" Cold
water Pipe
Feed water
adpater
3/8" Inlet
water tubing
Cold water
supply valve
1/2" Cold
water Pipe
Cold water
supply valve
Unscrew
Unscrew
Figure 3
Figure 1
Figure 2
