Step 2: Connect the water supply (cold water only)
1. Shut off the water supply. Remove the faucet hose. (Figure 1)
2. Connect the inlet hose to the cold water valve.
• If the angle valve outlet is 3/8”, it can be directly connected to the water supply. (Figure 3)
• If the angle valve outlet is 1/2”, connect it with a No.1 converter at first. (Figure 4)
Triple-Stage Undersink Water Filtration System
WD-TSA-10 system | Installation Instructions
Note:
The service life mentioned above is subject to chlorine reduction. Actual result varies according
to the local water quality.
Precautions
• Do not use it with water that’s microbiologically unsafe or of unknown quality without adequate disinfection.
• For use only with cold water.
• Do not freeze the filter, as this can cause cracking and water leakage.
• Do not allow children under 3 years old to have access to small parts during installation of this product.
• This installation must comply with all applicable state and local regulations.
• Turn off the water supply while replacing the filter.
Inlet hose
Outlet hose
Teflon tape
Filter head
3/8”-1/2” converter
Operating temperature
Working pressure
Flow rate
Filter capacity
2-38
℃
/35-100
℉
10-125psi (0.7-8.6bar)
1gpm
Specifications
Feed water requirement
Municipal tap water
WD-10PP: up to 6 months
WD-10GC: up to 8-12 months
WD-10CT: up to 12-18 months
Figure 3
Figure 4
3/8” outlet
1/2” outlet
Connect
①
to the cold angle valve
①
WARNING
Please read it carefully before installation.
Step 3: Connect to the faucet
1. If the angle valve outlet is 3/8”, it can be directly connected to the water supply. (Figure 5)
2. If the angle valve outlet is 1/2”, connect it with a No.2 converter at first. (Figure 6)
Figure 5
Figure 6
②
Faucet hose
Outlet hose
Faucet hose
Note:
If a female threaded connector is needed, please contact our service team for help.
Step 4: Connect to the filter system
Connect the inlet hose and the outlet hose to the filter head. Make sure the hoses hit the bottom of
the filter head.
Note:
When the hose is tightly inserted, there will be a 1/8 inch gap between the hose and the filter
head, which is designed for easy replacement and won't affect the sealing performance.
Step 5: Flush the filter and check the leaks
1. Flush the filter for 5 minutes before use.
2. If water leakage occurs, turn off the water supply. If the water leakage is occurring at position 1 and 2,
wrap Teflon tape on the external thread. If the water leakage is occurring at position 3 or 4, insert the
quick-connect fitting to the end and make sure the hoses hit the bottom of the fitting.
Inlet hose
Cold
Hot
Outlet hose
Filter system
Faucet hose
1
2
3
4
Figure 1
Inlet hose
outlet hose
Installation of the filter system
Tips: How to disconnect the quick-connect?
Use your thumb and index finger to press down on the lock sleeve. Use your other hand to pull out the
hose from the fitting.
Note:
Please do not pull out the tubing directly, or else it will damage the fitting and cause leakage.
Step 1: Fix the filter head and the filter
1. Paste the assistant label to finish drilling.
Note
: Mount the water filter at least 2 inches higher
than the ground for easier filter change.
2. Install the screw and reserve enough space to hang the filter.
3. Hang the filter system on the screw.
Press
Pull
Press
