Your A/V processor has a "Sub Pre Out" output, connect it via the
modulation cable (not supplied) to one of the two "Low level Input"
inputs on your subwoofer (either L or R). If it has an XLR output, connect
it via an XLR cable (not supplied) to the XLR input on your subwoofer.
Hi Level Inputs must not be used. Input switching is automatic.
Do not connect the 2 inputs (XLR and Low Level Input) at the same time.
Setting up your Audio Video processor
•
Configure all speakers in "small" mode
•
Choose 120Hz as the crossover frequency
•
Adjust levels and distances
In the case of "auto set up" configurations with microphones, check the
consistency of the settings afterwards.
SET UP & CONFIGURATION IN HOME CINEMA MODE
- 15 -