WaterGroup WG185ACF75, Owner'S Manual



Place the filter tank as close as possible to 

the pressure tank (well system) or water 
meter (city water). 



Place the filter tank as close as possible to 
a floor drain, or other acceptable drain 

point (laundry tub, sump, standpipe, etc.). 



Connect the filter to the main water supply 
pipe BEFORE the water heater.  DO NOT 

RUN HOT WATER THROUGH THE FIL-
TER. Temperature of water passing 

through the filter must be less than 100 

deg. F. 



Do not install the filter in a place where it 

could freeze. Damage caused by freez-
ing is not covered by the warranty. 



Put the filter in a place water damage is 

least likely to occur if a leak develops. The 
manufacturer will not repair or pay for wa-

ter damage. 



A 120 volt electric outlet, to plug the in-
cluded transformer into, is needed within 6 

feet of the filter. The transformer has an 
attached 6 foot power cable. Be sure the 

electric outlet and transformer are in 

an inside location, to protect from 
wet weather. 



If installing in an outside location, you 
must take the steps necessary to assure 

the filter, installation plumbing, wiring, 

etc., are as well protected from the ele-
ments, contamination, vandalism, etc., as 

when installed indoors. 



Keep the filter out of direct sunlight. 

The sun’s heat may soften and distort 

plastic parts. 

Where To Install The Filter 

6