Electrical work
05.06.2015
44 / 80
Copyright
2013 by: WATERKOTTE GmbH. Subject to changes.
10.2
Electrical connection indoor unit
10.2.1
Connection Temperature sensor
see chap. 6.2.7
10.2.2
Connection Touch Display
see chap. 6.2.8
10.2.3
Installing external wall sensor
Install external sensor (included in delivery) always vertically (even if tempo-
rary), with cable entry pointing downward. Next, tighten screw connection
sufficiently to allow sealing insertion of cable and to prevent water from en-
tering the housing.
When performing temporary installation, sensor might have to be mounted
on board, which is fastened to wall using a steel nail.
(Electrical connection, see chap. 10.3).
To prevent transport damages, front and side panels of heat distribution
station are separately enclosed.
After all connections are completed, install plates at specified positions (in-
sert and press).
10.2.4
Adjustment of the electrical heating element
The thermostat of the heat generator is permanent adjusted to 75 °C.
A G S 5 4