ARAMARK Manual
Page 43 – Revision 10-31-21
Installing the Filter Head
A Filter Head will need to be installed in the Refresh Center. The Filter Head was supplied to you via a
separate package from Waterlogic. To install the Filter Head, remove the Lower Front Panel that is
located under the Drip Tray of the Aramark Refresh Center
.
For UL certification purposes, this Lower
Door is secured with 2 screws located on the underside of the Aramark Refresh Center. UL requires
all areas of access to wiring and high voltage components to be protected such that access requires
the use of a tool. When you install the Aramark Refresh Center in a customer location, be sure that
these screws are re-installed to ensure no one inadvertently gains access to the internals
(compressor) and associated wiring.
1.
To remove the Lower Panel, lean the Aramark Refresh Centers unit back and remove the two
Philips-head screws on the bottom. Once the screws are removed, bring the unit back to the
upright position, and press in one of the detents in the bottom of the panel and remove. Note
that the Lower Panel on the Aramark Refresh Center unlocks.
