ARAMARK Manual
Page 44 – Revision 10-31-21
2.
Once the Lower Front door is removed, the Filter Head needs to be installed on the filter
support plate, as shown in the figure below. Connect the tubing to the fittings in the head
prior to actually mounting the head on the screws provided on the filter plate. This will
minimize the chances for kinking the water tubes.
Once the Filter Head is installed and piped, install a PRE-RINSED Filter into the Filter Head,
connect to a water supply, power the
Aramark Countertop or Refresh Center. Check for
Leaks
. Keep the Red Power Switch OFF (
O=OFF
) on the back of the unit until the tanks are
filled with water.
3.
To fill the Hot and Cold Tanks, Depress the Dispensing Button until water flows from the
faucet (requires about 60 seconds to fill the Cold Tank). Once the Cold Tank is filled,
momentarily depress the Hot Selection Button, notice the center LED changes from green to
red, then press the Dispensing Button until water flows from the Faucet indicating the hot
tank is full.
Note: When the Hot Selection Button is pressed and the center LED lights red, you have 2
seconds to begin dispensing water. If water is not dispensed within 2 seconds, the center LED
will revert to green (default dispense) and cold water automatically will be selected.
4.
Once the Hot and Cold Tanks are filled, turn on the Red Power Switch
I=ON
located
on the Back Panel of the Aramark Countertop or Refresh Center.