BLUPURA
Fizz 80
Manual
Page 23 ‐ Revision: 11‐2‐2018
CONNECTING TO WATER SUPPLY (FEED WATER)
17.
Ensure the incoming water pressure is between 14.5 and 51 PSI. Incoming flow rate needs to
be .80 Gallons per minute minimum.
18.
Install water line and filter to the incoming ¼” fitting on back of unit.
19.
Once the tubes are attached, turn on water supply and dispense from Tap. Ensure there are
no leaks.
CUT, SIZE AND CONNECT WATER AND CO2 PIPING TO FIT INSTALLATION
CAUTION!
WATER PRESSURE
Input or feed pressure must be 14.5 psi to 51 psi (.10 MPa – 0.35MPa). Be aware of any
potential pressure surges caused by building/municipal pumping stations. Water block
devices and external leak detectors are strongly recommended. Locate the unit as close to the
water supply and the electrical connections as possible to minimize risk.
CAUTION!
WEAR SAFETY GLOVES.
Wear safety gloves when handling the machine. Metal edges are sharp and touching them
could result in a minor moderate injury.
CAUTION!
CHECK ALL PIPING AND CONNECTIONS FOR LEAKS
Check all input piping and connections for leaks before connecting to the machine.
