The Cube Technical Manual - Version 1, May 2014
20
21
selecting the cold option until the water stops being dispensed. Isolate the power to
the machine by switching the red switch at the rear of the machine off and removing
the power lead.
12.
Remove the top cover from the machine. Then take out the filter(s) and unscrew
the housing, pour the excess water down the drain and re-fit the cartridge.
13.
Re-fit the filter(s) into the machine pushing it firmly into place. Replace the top
cover and re-connect the power lead, then turn on the red and green switches at
the rear of the machine. Turn on the water supply.
14.
Flush through the hot tank by dispensing water from the hot option. You will
need to flush approx. 4-8 litres of water.
15.
Smell and then taste the water and flush more water through the tank if needed.
16.
Using the antibacterial wipes, sufficiently clean the exterior panels of the
machine, including the drip tray and grill.
ADVISORY ICONS
HOT WATER
Press and hold the hot water icon
for 3 seconds until the icon has
illuminated orange, select the
dispense button and hot water will
be dispensed (This safety feature
prevents hot water from being
dispensed accidentally, especially
by children).
EXTRA HOT WATER
Press and hold the extra
hot water icon on the
display panel, the icon
will flash red to indicate
that the water is heating.
Once the icon turns
off, the water is at the
correct temperature
and extra hot water can
be dispensed following
the same method
as Hot Water.
POWER /UV
OK
DISPENSING
BUTTON
Press and hold this icon
after selecting the type
of water you wish to be
dispensed, when your
cup has reached the
desired level release the
button.
COLD
WATER
Select
cold water
and press
dispensing
button.
AMBIENT
WATER
Select
ambient
water
and press
dispensing
button.
UV LAMP
HAS FAILED
Replace UV
lamp.
FILTER
SERVICE
DEMAND
Replace filter
cartridge.
A LEAK
HAS BEEN
DETECTED
Turn off the
water supply
and call your
authorized
service agent.
