19.
Leave the sanitation fluid to stand in the cold tank for 10 minutes. Once this time has passed
select the cold water icon and then select the dispense button and flush 10 liters of cold
water and 4 liters of ambient water through the machine. Use the same method as before
and check all the sanitation fluid has left the tank by using a chlorine test strip
20.
Turn off the water supply at the isolation point
21.
Select the cold water icon and then the dispense button until no more water
is being dispensed.
22.
Switch off the Red Power Switch at the rear of the machine
O=OFF and remove the power lead from the unit.
23.
Use a Phillips-head screwdriver to remove the two screws at the rear of the
machine that hold the top panel.
24.
Remove the top panel by placing your hands on the top as shown in the
picture and push it backwards and then lift it up to remove.
25.
Insert your finger into the round hole of the lever, and pull
the lever up to the vertical position.
26.
Pull the lever straight up to remove the filter assembly (some slight force may
be required)
CUBE
Operating, Installation, and Service Manual
Page 22 - Revision: 6-23-2015
