WL1000GF MAX
Manual
Page 49 Revision 10-7-2017
6.
Small Amount of Water Periodically Dispenses from Faucet Automatically
Possible Reason
Solution
Obstruction in solenoid
housing is preventing proper
sealing of component.
Drain unit according to Drain Instructions that are included
further below in this Troubleshooting Section.
Remove Reservoir Tank
Open Faucet Housing and check for Debris.
Put faucet back together, replace reservoir and fill unit. If
faucet continues to drip, replace the faucet.
7.
Dispense Buttons Stick
Possible Reason
Solution
Dirt or Foreign material is
filling the gap around the
push-buttons.
Inspect the push buttons and clean surrounding area.
Inspect faucet assembly inside the unit and clean as
necessary.
8.
Water Leaks
Possible Reason
Solution
Water Leak
Most leaks will be detected by the internal
WL1000GF MAX
Water Treatment System
leak detection system that will
trigger or turn off the inlet solenoid valve.
Isolate the supply and start normal fault finding procedures.
