WL270
Manual
Page 54 – Revision 3‐4‐2019
7.
Replace the Access Panel and 4 Philips screws.
8.
Plug in the Power Cord.
9.
Make sure the hot and cold tanks are filled with water BEFORE turning on the Red
Heater and Compressor Power Switch
CAUTION!
NEVER TURN ON HEATER BEFORE FILLING HOT TANK.
Red Heater and Compressor Power Switch
must be in the O=OFF position
while the Hot Tank is empty. Damage could occur within one minute and
the overload (high limit) will require manual reset if heater is turned on
with an empty Hot Tank.
10.
Verify the cooler is fully operational before installing it at the customers’ site.
