WL3 FW
User Manual
Page 12 - Revision: EU 17-09-2020
OPERATING INSTRUCTIONS
TO DISPENSE PURIFIED COLD WATER:
Select cold dispense icon until it lights and hold until desired amount is
dispensed.
Release to stop dispense.
There will be a 2 second initial delay as Firewall purifies cold water and
sanitizes the faucet. Cold will only dispense if Firewall is active to guarantee safest possible water. Cold
icon and Firewall Purification Light are disabled if Firewall is inactive. One minute continuous dispense
limit.
TO DISPENSE PURIFIED AMBIENT (ROOM TEMPERATURE) WATER:
Select ambient dispense icon (lower) until it lights.
Hold until desired amount is dispensed.
Release to stop dispense.
There will be a 2 second initial delay as Firewall purifies ambient water and
sanitizes the faucet. Ambient will only dispense if Firewall is active to guarantee safest possible water.
Ambient icon and Firewall Purification Light are disabled if Firewall is inactive. One minute continuous
dispense limit.
TO DISPENSE SPARKLING WATER:
Select Sparkling dispense icon (lower) until it lights.
Hold until desired amount is dispensed.
Release to stop dispense.
There will be a 2 second initial delay as Firewall purifies sparkling water and sanitizes the faucet.
Sparkling will only dispense if Firewall is active to guarantee safest possible water. Sparkling icon and
Firewall Purification Light are disabled if Firewall is inactive. One minute continuous dispense limit.
WARNING!
HOT WATER can cause severe burns or scalding. Unit produces Hot Water(87
o
C /189
o
F).
Keep unauthorized people and children away from the unit to avoid injury and accidental dispensing.
TO DISPENSE HOT:
Select HOT (middle) and AMBIENT/SPARKLING (lower) together until both light
Hold until desired amount of hot is dispensed.
Release to stop dispense
.
Icons must be held simultaneously for 2 second before hot will dispense.
This delay is a safeguard to prevent accidental dispense or unauthorized use.
NOTE:
Hot water may not be immediately available if unit is in energy saver
mode. Select any icon to “wake up” or reactivate heater and wait a few minutes
for hot water to be produced.
WL3 FW
User Manual
