Flush Filters
CAUTION!
FILTER FLUSH REQUIRED.
In order for our filters to perform as represented and to provide the best quality water possible, it is
essential that filters be replaced periodically. The frequency of filter changes depends upon your
water quality and your water usage. For example, if there is a lot of sediment and/or particles in
your water, then you will have to change your filters more frequently than a location with little to no
sediment. Be sure to replace your filters whenever you notice a decline in the performance, whether
it is a drop in flow rate and/or pressure or an unusual taste in the water.
4.
Flush thoroughly per filter manufacturers’ recommendation with fresh water to drain.
5.
Once flushed, install the filters. Following the flow direction on the filter.
NOTE:
Filters should not be flushed prior to 24 hours before installation to limit Microbial Growth.
Sanitizing
Sanitize using a household bleach solution or other approved cleaner throughout the cold and sparkling
water circuits. Follow all instructions on the sanitizer and flush with fresh water through the faucet
until odor and taste is acceptable.
WARNING!
USE PROPER PERSONAL PROTECTIVE EQUIPMENT
Always ensure proper ventilation and use proper personal protective equipment such as gloves and eye
protection when using chemicals. Refer to Material Safety Data Sheet for specific requirements of each
chemical product. Take all necessary precautions to prevent sanitizer from contacting eyes, clothing, and
any other surfaces in could damage (carpets).
6.
Connect 40-60 psi regulated, potable water supply to the water inlet bulkhead fitting located on the
back of the unit. Turn on water supply and check for leaks.
DANGER!
ELECTRICAL SHOCK HAZARD.
Do not plug in unit unless qualified. Only qualified personnel who have read and understand this
entire manual should attempt to install or service this unit.
7.
Connect
WL800
to power and allow unit to fill completely.
8.
Mix ½ gallon of sanitizer per directions or use Bleach Solution (1 teaspoon = 1/6 oz. = 5 ml = ½ cap
full) of household bleach (Sodium Hypochlorite 5 - 10% Concentration) with 1/2 gallon of water.
Always ensure sanitizer is compatible with stainless steel and acetal plastic.
9.
Pour sanitizer into reservoir.
WARNING!
Use Personal Protective Equipment. Gloves and Eye Protection Required. The first 2
or 3 gallons of water will contain concentrated sanitizer. Use extreme care!
WL800
Operating, Installation, and Service Manual Page 35 - Revision: 5-14-2015
Summary of Contents for WL800 - MAX II
