Assembly and Operating Instructions Fast Set Pool “WATERFUN”
English
11
32mm
Filter
38mm
RET
URN
FILLING WITH WATER
First close the two transparent screen valves
from the inside, and the two black hose
adapters in the aperture on the pool wall from
the outside. You can now attach the 32 mm
hose directly to a hose adapter. An adapter for
attaching the 38 mm hose is included. Please
connect the hoses to the pre-assembled sand
filter system (see separate manual for sand
filter system).
The 32 mm hose is connected to the suction
side of the pump, and the 38 mm hose to the
"return" port of the 6-way valve. Alternatively,
you can also seal the two hose connections
from the inside with the enclosed blue sealing
caps. In this case, however, you should fill the
water only up to just below the valves, and
then establish the connection to the sand filter
system. Please check again if the drain valve
of the pool is securely closed.
Never use well water, rain water, fire-fighting
water or water from a reservoir or retaining
basin to fill your pool. The consequential
costs for the treatment of unsuitable water are
considerably higher than the cost of tap water.
Preferably fill your pool with a garden hose
and use only drinking/tap water. You can
easily adjust or correct wrinkles on the floor
up to a water (filling) level of approx. 3 cm.
Always ensure an all-over, uniform levelling. If
the water height at the pool edge is uneven,
the ground of the pool has probably not been
properly levelled. This must be corrected.
The maximum filling height for the pool is up
to the lower weld of the tube ring. Never leave
the pool unattended during the filling process.
The maximum filling quantity is 80% of the
capacity of your pool.
An overfilled pool can cause tearing of the
pool wall. You may have to drain water when
there is heavy rainfall. If there are bulges on
the outer pool wall, the ground is probably
slanted and must be corrected.
3cm
max.
73cm
