5.
Drill the holes, using a 6.5mm (
1
/
4
”) masonr y bit.
On tiled sur faces, the applied adhesive
tape will help guide the drill bit, Fig. 17.
6.
Using two of the wall plugs and the screws supplied,
attach bottom bracket to the wall, then slide on the
bracket cover, Fig. 18 and 19.
7.
Depress the lock button on the shower handset
slider, Fig. 20, and locate it in the centre of the riser
rail. Slide on the upper and lower location collars and
the contrast colour discs, noting the correct
orientation shown in the inser t views of Fig. 21.
8.
Inser t the lower end of the riser rail into the bottom bracket, locating its slot
over the tongue in the aper ture and press down the collar and disc to snap
them home.
9.
Using a screw, attach the top bracket through the central slot. Do not fully
tighten this screw, allowing for final positioning. Slide on bracket cover.
10.
Inser t upper end of riser rail into top bracket and press down on bracket cover
to determine a secure mounting, at the same time passing a screwdriver
through the large hole in the rail and through the bracket to locate the
mounting screw, which should now be tightened fully, Fig. 22. Finally clip home
the top bracket location collar with its contrast colour disc.
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
8
