13. OPERATING YOUR NEW SHOWER – Manual Model
Ensure that electric and water supplies are turned on.
Turn on the shower by turning the temperature control knob anti-clockwise.
Adjust temperature as required. Flow rate can be varied by adjusting the flow control
knob.
Turn of f the shower by turning the temperature control knob fully clockwise.
There is no need to adjust the flow control when turning of f the shower.
14. OPERATING YOUR NEW OSPREY –
Thermostatic Model
Ensure electricity and both hot and cold water supplies are turned on. Turn on the
shower by pushing on/of f flow control knob.
Adjust temperature and flow rate as desired.
To turn of f, push on/of f flow control knob.
The temperature control is independent of the on/of f flow control and can be
left in the selected temperature position until the next time the shower is used.
There is no need to set to cold position.
The first time the shower is used there may be some residual air in the
system. This may cause uneven flow, spitting from the shower handset and unusual
noise from the pump. This should clear quickly and disappear with fur ther use.
Note:
If the water flow stops but the pump continues to run, switch of f immediately.
Refer to Fault Finding Section 11, paragraph C.
15. SERVICING
The most common cause of poor shower per formance is blockage of the handset
spray plate holes. They are usually blocked by dir t or limescale deposits, which is
more common in hardwater areas. Regular cleaning and descaling is recommended.
To maintain a good flow and spray pattern the handset should be cleaned
regularly. In hard water areas it should also be descaled dependent upon the rate of
scale build up.
The sur faces of the cabinet, hose, riser rail and handset should be cleaned
with a non abrasive cleaner only.
12
