Safety
Introduction
Product Overview
Installation
Operation
Maintenance
Troubleshooting
Warranty
26 | 44
Installation overview
The slide-in module consists of a engine, compressor, foam pump, fire pump,
and control panel, mounted on a steel frame. They are designed to slide into
commercially available vehicles. You can add a water tank to make an all in one
system. Otherwise, the equipment can draw from external water source.
This equipment system is intended to be installed by a person or persons with
the basic knowledge of installing similar equipment. Contact Waterous with
questions about installing the equipment. The installation, in-part, requires the
following tasks and abilities:
•
Lifting the equipment into a vehicle
•
Locating, drilling, and cutting
features into the vehicle
•
Connecting the fuel supply and
return to the motor
•
Connecting power to the equipment
•
Checking, adding or filling fluids
•
Final testing
Equipment Requirements
•
The engine requires fresh air suitable for combustion and cooling. Do not
enclose the equipment within the apparatus without providing adequate
ventilation for heat buildup and suitable fresh air intake. Not providing
adequate ventilation and suitable fresh air intake will cause premature
equipment failure and void your warranty. Contact Waterous for more
information.
•
The system requires 12 Vdc and a frame ground to operate. Make sure that
you provide suitable electrical cables to power your application. Contact
Waterous for more information.
Note:
Some modules use 24 Vdc.
•
The system requires a fuel lift pump and hoses suitable for your application.
Contact Waterous for more information.
Preparing for the Install
Read and understand the install instructions before installing the equipment—
Contact Waterous with questions about installing the equipment. Make sure
that you do the following before you install the equipment:
•
Prepare a suitable, well lite, area, and gather all the necessary tools before
you install the equipment:
•
Make sure that the forklift is rated to lift the equipment.
•
Make sure that the vehicle is rated to operate with the equipment and supply
tanks used in your application.
•
Ensure that you provide adequate ventilation.
Modifying the Equipment
This equipment is intended to operate as designed. Do not remove, modify, or
change the components in the system. Doing so will void the warranty. Contact
Waterous for more information.
NOTICE
Modifying the equipment
can damage components
and void your warranty.
•
Do not modify the foam
system.
•
Modification
Do not modify the system or any components. Doing so will void your
warranty.
Summary of Contents for ECLIPSE CAFSystem 2.0
Page 2: ......
