T-360
Page 21 of 35
Reassembly of the Shift Assembly
1.
File and clean sealing surfaces of the mid-section and clean out any
metal chips or shavings.
2.
Apply a small amount of grease to the O-ring and install on the groove
of the pivot pin. Apply Loctite #242 to the pivot pin per Figure 31 and
install into the mid-section.
NOTE: Avoid getting Loctite #242 on O-ring surface.
3.
Install the sleeve bushing 1/2" down into the shift shaft bore. Apply
silicone sealant to the outside diameter of the flange bearing and then
install it into the shift shaft bore. Make sure there is a 1/8" gap between
the bushing and bearing.
4.
Apply a small amount of grease on the O-ring and install between the
bushing and bearing.
5.
Install spirol pin in mid-section.
6.
Install the spring housing into the spirol pin.
Figure 31. Pivot Pin, Shaft Bushing and Sleeve Bearing Installation
Pivot Pin
Mid-section
O-ring
Shaft Bushing
O-ring
Shaft Bearing
Shift Assembly
1.
Invert mid-section.
2.
Attach shift arm to shift shaft with spirol pin (
see Figure 32).
3.
Install shift lock spirol pin in shift arm.
4.
Grease the shift shaft.
Figure 32. Shift Arm Assembly
IL2521
Mid-Section
Spirol Pin
Spring Housing
Shift Lock Spring
Spriol Pin
Shift Arm
Shift Shaft
V-Ring
Spirol Pin
