T-360
Page 22 of 35
Figure 33. Shift Assembly
Adjusting Screw
IL2195
IL2232
Sector Spacer
Shift Lever
Sector Gear
Pivot
Pin
Locking
Arm
Shift
Shoe
Shoulder
Screw
Shift Shaft
Locking Nut
Screw Retainer
IL2249
Also See
Pages
20 & 21
5.
Slide the shift lever into the sector gear aligning the holes (
see Figure
33).
6.
Set shift lever/sector gear over the shift shaft opening in the mid-sec
tion.
7.
Slide shift shaft up through the shift shaft opening, engaging spacer
and shift lever or shift lever/sector gear.
8.
Install the shift lock spring into the spring housing (
see Figure 32
).
9.
Engage shift arm spirol pin with the shift lock spring (
see Figure 32
).
10. Rotate the shift arm to compress the shift lock spring into the housing.
Line up the holes in the shift lever/sector gear and install shoulder
screw and locking nut.
11.
Install the locking arm onto the pivot pin (see Figure 33) and mesh the
teeth with the sector gear. Proper alignment is important. The center
tooth space in the sector gear should be centered with the locking arm.
12.
Install the shift shoe assembly on the pin of the locking arm.
NOTE: Shift shoe can be installed with the counter bore either up or
down.
NOTE: Shift mechanism may not shift smoothly until bottom cover is
installed.
13.
Install adjusting screws in the mid-section and adjust so the locking
arm is rotatable slightly less than 90
_
each direction (
see Figure 33).
14.
Install screw retainers. Place a dab of grease on the retainers to hold
them in place until the shift unit or cover can be installed.
15.
Check assembly for proper shifting.
