8
Control panel installation
The control panel should be installed at the edge of the bath/hot tub for the
user’s convenience.
The location of the control panel should not be located under the joints of water
pipes and the water faucet.
1. Cut out a hole of diameter 55mm in the desired location.
2.
Place rubber washer over the hole.
3.
Insert the control panel
4.
Fasten the panel with the plastic nut.
The panel may be angled and swiveled to the desired location but please take
care not to knock the panel as this may break the plastic connectors.
Speaker installation
The speaker provided is IPX4. This is rated as resistant to light showers. If
positioning in a bathroom it is ideally situated in the ceiling. If this speaker is to
be used in a gazebo structure it should be located where it will receive most
shelter from the elements.
1. Select a mounting location which will allow the speaker to lay flat.
2. Use the supplied template to mark the mounting holes.
3. Drill a starter hole in the center of the mounting hole and cut out using a
hacksaw or similar tool.
4. Connect the speaker wire to the speaker terminals using solder or
speaker spades.
5. Place a bead of RTV sealant (or equivalent) around the back of the
speaker basket.
6. Secure the speaker with fixing screws.
END
