LED flashes upon detection
Autosave is in
SETUP
mode
1
FILL
Press & release blue FILL button
- valve opens
ENSURE CISTERN IS EMPTY!
LED flashes while cistern fills
That's it - finished!
Autosave is now in
RUN
mode
When cistern starts to flush .....
Press & release blue FILL button
- valve closes
FILL
2
3
Autosave
B02
with remote valve - setting-up guide
Allow 30 seconds settling time
Connect 4 x AA batteries
4
B02b Rev 1.1
*
TO EMPTY CISTERN:
follow steps 1 to 3 until cistern flushes, disconnect battery, re-connect then follow setup guide again.
*
TO RETURN TO SET-UP MODE:
Disconnect battery, press & hold blue FILL button while re-connecting battery.
Release button. Autosave is in setup mode again.
PLEASE NOTE:
LED will flash TWICE in setup mode and ONCE in run mode upon connection of batteries.
PLEASE LEAVE THESE INSTRUCTIONS WITH THE END USER - THANK YOU
1
2
3
4
ON
20MINS
12-24HRS
5MINS
10MINS
(HYGIENE)
1
2
3
4
ON
20MINS
12-24HRS
5MINS
10MINS
(HYGIENE)
Watersavers
Autosave - B02
0 1 6 0 3 7 2 0 9 9 9
Watersavers
Autosave - B02
0 1 6 0 3 7 2 0 9 9 9
IMPORTANT!!! Once in RUN mode the
LED does not flash upon detection
- use Magi-Test wand to check operation
