Step 1
Disconnect the hose from the tap & clean the thread
with sand paper to remove any debris.
Now wrap the thread of the tap with Teflon tape.
Step 2
Ensure at least 2 washers are inserted into the top
connector of the CLEO and wrap the bottom connector
thread with Teflon tape to prevent leaks
Step 3
Align the top connector of the CLEO with the thread
connector of the tap & rotate clockwise to tighten
Step 4
Flushing – Turn on the water and step away from the
path of the water. Let the water flow out for 3 minutes.
This will flush out discoloured water – this is just carbon
dust, and it is not harmful.
Step 5
Align the hose connector of your hand-shower
with the bottom thread connector of your CLEO and
rotate clockwise to tighten fully.
Use a spanner to tighten fully. If there are leaks,
check/insert washer and tighten again.
Installation on
Hand-showers fixtures
Summary of Contents for Cleo SFU-717
