VEN-038-CKP Rev. A
41180 Raintree Court • Murrieta, CA 92562 • 1-888-304-0660 • 951-304-0520 •www.waterstoneco.com
G
H
L
M
K
J
A
D
E
C
B
F
1-1/2”
HOLE
1.
2.
3.
4.
5.
6.
Unscrew and remove top clamp
nut (D) from both threadings on
piping. Slide gasket (E) off piping
and remove.
Pull air gap (A) off of upper cap
nut (B). Unscrew and remove
cap nut from piping (C).
Slide gasket down and screw
top clamp nut back onto piping.
Adjust the two clamp nuts to
fit countertop thickness.
(No
plumbers putty is required)
.
Screw cap nut back onto
top of piping until snug.
Slide air gap over cap
nut and top clamp nut.
Be sure to have overflow
holes (F) facing sink.
From underneath counter
top, fit air gap piping upward
through 1-1/2” hole.
Slide small intake hose (G) over small connector.
Slide larger drainage hose (H) over large
connector. Tighten hose clamps.
Third intake hole (J)
has 3 options. Use
hose connector (K) for
additional dishwasher,
use filtration hose
connector (L) for reverse
osmosis unit, or use
solid cap (M) to plug
third hole.
INSTALL DUAL PORT AIR GAP (OPTIONAL)
