HANDHELD JET INSTALLATION
To install the handheld jet, unscrew an existing Waterway poly jet (turn counterclockwise). The
existing jet may require a jet wrench for removal, available from your local spa retailer.
If the existing jet features a metal trim ring, it may have to be removed to allow removal of the
existing jet and installation of the new jet. This ring can be removed by prying around its edge
with a flat-head screwdriver. Use care to avoid prying the plastic jet body from the spa wall as
this will cause the spa to leak.
Using your finger tips, screw in the handheld jets internal, until it locks in place. The handheld jet
may be cleaned using any mild soap.
DO NOT
use abrasive or solvents for they can damage the
plastic parts.
Spa
Existing Poly
Jet Body
Handheld Jet Body
Tip: Once installed, rotate the jet’s trim ring to adjust
the water flow of the jet to your specifications
810-0007.0618
©2018 Waterway Plastics
2200 East Sturgis Road, Oxnard CA 93030 • Phone 805.981.0262 • Fax 805.981.9403
www.waterwayplastics.com • waterway@waterwayplastics.com
Designed,
Engineered &
Manufactured
in the USA.
WARRANTY
For product registration visit: www.waterwayplastics.com.
For Warranty questions or claims please contact point of purchase.
