Option 2: Flush Mounting
1. If pool wall has been pre-punched and pre-drilled than skip to Step #7.
2. Cut out pool wall panel per the dimensions in the following table:
NOTE:
The screws secure through the following: 1) The face plate, (2) Gasket, (3) Vinyl Liner, (4) Pool Wall, (5) Gasket, and into (6) Skimmer Face.
CAUTION:
(1) Do not stress pipe at the port connections by lifting or moving the pipe after skimmer port connections have been made.
(2) Be sure to plug any unused skimmer ports with plastic style NPT Plugs provided (Item #23 for 2
″
NPT or #24 for 1
1
⁄
2
″
NPT). Failure to
do so will void the manufacturer's warranty. (3) If you need to pressure test the skimmer after installation, use Waterway's Pressure Test
Kit (Part Number 540-6500).
4. Using a 7/32
″
diameter drill bit, drill out the holes you marked in step #3.
5. Repeat step #3 bit instead of marking the skimmer mounting holes, Mark the location of the remaining holes.
6. Using a 9/32
″
diameter drill bit, drill out of the holes you marked din step #5.
7. Mount the gasket (Item #10 for Standard or Item #22 for Wide Mouth) on the skimmer face by aligning the tabs on
the back of the gasket with the tab slots in the skimmer face and push into place.
8. Secure the skimmer to the pool wall by using the four 1
1
/
4
″
long phillips pan head screws provided (Item #19).
9. Install your Vinyl Liner by by following the pool manufacturer's instructions.
10. Push the second gasket (Item #10 for Standard or Item #22 for Wide Mouth) onto the back of the face plate (Item #9
for Standard or Item #21 for Wide Mouth) the same way you put the gasket onto the face of the skimmer in step #7.
11. Tightly fasten the faceplate/ gasket to the skimmer face by the 1
1
/
4
″
phillips flat head screws provided (twelve (12)
screws for the Standard and sixteen (16) screws for the Wide Mouth, Item #8). Make sure to pierce the Vinyl Liner
through the face plate holes one at a time prior to inserting screws.
12. Cut out Vinyl Liner along the inside edge s of the face plate.
3. Center the opening in the gasket (Item #10 for Standard or Item #22 for Wide Mouth) over the cut out in the pool wall
and mark the location of the four (4) skimmer mounting holes. (See Figure S-2 for Standard Throat or Figure W-2 for
Wide Mouth.
3
STANDARD RENEGADE
WIDE MOUTH RENEGADE
Height
Min
Width
Height
Width
Max
7
11
/
16
″
7
9
/
16
″
9
7
/
8
″
9
3
/
4
″
9
3
/
4
″
9
3
/
4
″
17
7
/
16
″
17
5
/
16
″
Min
Max
Min
Max
Min
Max
Summary of Contents for Renegade
Page 6: ...6 Section VI Dimensions...
