USING THE WATERWISE 3200 DISTILLER
Operational maintenance and replacement requirements are essential for
this product to perform as advertised.
1. Set Distiller on a dry, level, well-supported, stable surface.
2. Provide adequate air space (at least 4 inches from walls or cabinets)
around the distiller for proper cooling/ventilation.
3. Rinse kettle thoroughly before filling to “MAX” lines with
approximately 1 gallon of ordinary tap water. DO NOT fill above
“MAX” fill lines (fig. C).
4. Replace kettle cover. Twist clockwise to lock. Slide kettle into base unit
and press firmly to ensure kettle is properly placed (fig. A).
5. Slide carafe into base unit.
6. Plug power cord into a grounded 120-volt outlet.
7. Press the “Reset” button on the kettle to turn Distiller ON (fig. A). The
“Indicator” light will illuminate. The cooling fan will not start immedi-
ately because of a delayed fan start-up feature. The fan will start once
the kettle has reached a predetermined temperature, approximately 30
minutes after starting the cycle. The cooling fan will continue to operate
approximately 1 minute after kettle turns off. When cycle is complete
(approximately four hours for 1 gallon), Distiller turns off automatically.
WARNING: Never remove the kettle while the fan motor is running
or for 30 minutes after a completed cycle. If cycle is interrupted, restart
and allow cycle to complete or wait at least 5 hours before removing the
kettle to allow water to cool.
8. Discard first gallon of distilled water as it may contain some harmless
matter from manufacturing and/or packaging.
9. To pour water from carafe, open spout by pulling on center strip in
direction of arrow indicator near thumb position.
10. Purified, distilled water may be stored in carafe in the refrigerator, if
preferred.
Waterwise 3200 Use & Care Guide
7
Figure
C
“MAX” Fill Lines
Kettle Cover
(Bottom
View)
Kettle
Gasket
Kettle
