WATER TERMINOLOGY
The following chemical terms are used in this Water Quality and Maintenance section. Understanding their meaning will
help you to better understand the water maintenance process.
Bromamines: Compounds formed when bromine combines with nitrogen from body oils, urine, perspiration, etc. Unlike
chloramines, bromamines have no pungent odor and are effective sanitizers.
Bromine: A halogen sanitizer (in the same chemical family as chlorine). Bromine is commonly used in stick, tablet, or
granular form. See the DO’s and DON’Ts of Spa Water Maintenance for additional information.
Calcium Hardness: The amount of dissolved calcium in the spa water. This should be approximately 150-200 ppm. High
levels of calcium can cause cloudy water and scaling. Low levels can cause harm to the spa equipment.
Chloramines: Compounds formed when chlorine combines with nitrogen from body oils, urine, perspiration, etc.
Chloramines can cause eye irritation as well as having a strong odor. Unlike bromamines, chloramines are weaker, slower
sanitizers.
Chlorine: An efficient sanitizing chemical for spas. Watkins Manufacturing Corporation recommends the use of Sodium
Dichlor-type granulated chlorine. This type is preferred because it is totally soluble and nearly pH neutral.
Chlorine (or Bromine) Residual: The amount of chlorine or bromine remaining after chlorine or bromine demand has been
satisfied. The residual is, therefore, the amount of sanitizer which is chemically available to kill bacteria, viruses and algae.
Corrosion: The gradual wearing away of metal spa parts, usually caused by chemical action. Generally, corrosion is
caused by low pH or by water with levels of TA, CH, pH or sanitizer which are outside the recommended ranges.
DPD: The preferred reagent used in test kits to measure the Free Available Chlorine.
Halogen: Any one of these five elements: fluorine, chlorine, bromine, iodine and astatine.
MPS: Monopersulfate is the non-chlorine oxidizer used with the FreshWater
Ag+
®
Silver Ion Purification system.
Pathogen: A microorganism such as bacterium that cause disease.
pH: The measure of the spa water’s acidity and alkalinity. The recommended pH for the spa water is 7.4 to 7.6. Below 7.0
(considered neutral), the spa water is too acidic and can damage the heating system. Above 7.8, the water is too alkaline
and can result in cloudy water and scale formation on the shell and heater.
ppm: The abbreviation of “parts per million”, the standard measurement of chemical concentration in water. Identical to
mg/l (milligrams per liter).
Reagent: A chemical material in liquid, powder or tablet form for use in chemical testing.
Scale: Rough calcium-bearing deposits that can coat spa surfaces, heaters, plumbing lines and clog filters. Generally,
scaling is caused by mineral content combined with high pH. Additionally, scale forms more readily at higher water
temperatures.
Shock Treatment: Also known as “super-chlorination” when chorine is used. Shock treatment is a process of adding
significant doses of a quick dissolving sanitizer (MPS or sodium dichlor is recommended) to oxidize non-filterable organic
waste and to remove chloramines and bromamines.
Total Alkalinity: The amount of bicarbonates, carbonates, and hydroxides present in spa water. Proper total alkalinity is
important for pH control. If the TA is too high, the pH is difficult to adjust. If the TA is too low, the pH will be difficult to hold
at the proper level. The desired range of TA in spa water is 125 to 150 ppm.
Water Terminology
Page 30
Summary of Contents for HOT SPOT RE
Page 1: ...Owner s Manual ...
