H
OW
T
O
A
DD
C
HEMICALS
T
O
T
HE
W
ATER
IMPORTANT:
All spa water chemicals, including granulated dichlor, MPS, granulated pH increaser or decreaser, granulated total
alkalinity increaser, calcium hardness increaser, liquid stain and scale inhibitor, and liquid de-foamer must always be added directly
into the filter compartment while the jet pump is running in high speed mode, and it must run for a minimum of ten minutes.
T
O ADMINISTER SPA WATER CHEMICALS
:
1. Fold back the cover. Carefully remove and set aside the filter compartment cover.
2. Push the JET button twice to turn the jet pump on in its high speed mode.
3. Carefully measure the recommended amount of chemical and slowly pour it into the filter compartment. Use care not to splash
chemicals on your hands, in your eyes, on the spa shell surface or on the siding.
4. Replace the filter compartment cover. After ten minutes, shut off the jet pump and close and lock the cover to complete the
procedure.
Risk of Drowning:
Never leave an open spa unattended!
WARNING:
High sanitizer levels can cause discomfort to the user’s eyes, lungs and skin. Always allow the sanitizer level to fall to the
recommeded range before using the spa.
IMPORTANT “SUPER CHLORINATION/NON-CHLORINE SHOCK TREATMENT” NOTE:
After administering a super
chlorination treatment or non-chlorine shock to your spa, leave the cover open for a minimum of 20 minutes to allow the oxidizer gas
to vent. A high concentration of trapped oxidizer gas which may exist as a result of the shock treatment (not daily sanitation) may
eventually cause discoloration or vinyl degradation to the bottom of the cover. This type of damage is considered chemical abuse and is
not covered under the terms of the limited warranty.
39
™
Summary of Contents for Solana
Page 1: ...Watkins Manufacturing Corporation OWNER S MANUAL...
Page 2: ......
Page 61: ...NOTES 59...
Page 62: ...NOTES 60...
