5 - Error Conditions, Problems and Solutions - Book Quality
36
Océ BLM500 Operator Manual
Book Quality Problems
Book Quality
Problem
Cause
Solution
The finished book is
not tidy
The wrong paper size
was entered on the
touch screen.
Measure the paper and enter the
correct dimensions. See “Enter
the Job Settings” on page 6.
The book is made from
paper that is different
sizes.
Only use paper of the same
size. See “Paper Size and Book
Quality Instructions” on page 35.
The BLM500 adjustment
system is not calibrated
correctly.
Touch
RE-REF
in the
PAPER
SIZE
window to calibrate the
BLM500 adjustment axes. See
“RE-REF” on page 18.
The static elimination
bars are dirty.
Clean the static elimination bars.
See “Clean the Static Elimina-
tion Bars” on page 52.
Incorrect function of the
static elimination bars.
Call your service engineer.
The spine is not
formed correctly
The
SET THICKNESS
is
incorrect.
Measure the set thickness and
enter the correct dimension.
See “Enter the Job Settings” on
page 6.
The settings for
FORM
or
PRESSURE
are incor-
rect.
See “Spine Form Problems” on
page 38.
The square spine is
not formed
The
SET THICKNESS
is
less than the spine form
THRESHOLD
.
Decrease the
THRESHOLD
value. See “THRESHOLD” on
page 16.
The
FORM
function is
turned off.
Turn on the
FORM
function.
The finished book is
not tight
The spine needs more
form.
Increase the pressure on the
spine. See “PRESSURE” on
page 16.
Increase the amount of spine
form. See “FORM” on page 15.
The book is not
trimmed
The
TRIM
function is not
selected.
Turn on the
TRIM
function. See
The trim position is set
larger than the book.
Reset the trim position. See
“TRIM” on page 16.
The book is not
trimmed square
Trimmed paper has col-
lected on the trim stop.
Clear the trimmed paper from
the trim stop. See “Jam in the
Trim Area” on page 43.
