3 - The User Interface - The BASIC Window
16
Océ BLM500 User Manual
- PRESSURE
Touch
PRESSURE
to increase or decrease the pressure used
to form the spine.
Touch
+
to increase the amount of spine form. Touch
-
to
decrease the amount of spine form. The range is -9 to +9. The
default setting is 0.
- THRESHOLD
The square spine is formed only on sets thicker than 0.8mm.
To change this value, touch
THRESHOLD
and enter the value
you need. The maximum value is 1.5mm.
TRIM
The trim dimension is calculated automatically according to
the
PAPER SIZE
and
SET THICKNESS
.
If needed, the trim dimension can be changed. Touch
TRIM
to
adjust the size of the finished book after the fore-edge is
trimmed. The maximum trim is 30 mm.
The trim function can be turned off.
Button
Information
