5 - Error Conditions, Problems and Solutions - Calibrate the Touch Screen
46
Océ BLM500 Operator Manual
Clear the Jammed Wire
Calibrate the Touch Screen
When to do
Calibrate the touch screen if the buttons do not operate or the buttons do not
operate correctly
Step
Action
Information
1
Cut the stitch-wire at position ‘A’,
approximately 50mm (2-inches)
from where the stitch-wire leaves
the stitch-wire guide.
2
Cut the stitch-wire at position ‘B’,
between the feed gears and the
middle wire tube.
3
Pull the stitch-wire from the stitch-
wire guide block.
4
Pull the stitch-wire from the middle
wire tube.
If there is not enough stitch-wire
left to pull, then follow the proce-
dure “Remove the Stitch-wire from
the Stitch Head” on page 59.
5
Install the stitch-wire into the stitch
head.
See “Install the Stitch-wire into the
Stitch Head” on page 60.
‘A’. Cut stitch-wire here.
‘B’. Cut stitch-wire here.
Pull stitch-wire in direction of arrow
