6 - Maintenance - Clean the Former Roller
54
Océ BLM500 User Manual
Procedure
Clean the Former Roller
When to do
Clean the former roller if the spines of the books are dirty. Ink and toner can col-
lect on the former roller.
Materials needed
Clean, plain paper that is not printed. A3 size (USA: 11 x 17”) is recommended.
4mm thickness is needed for each cycle. More than one cycle can be needed.
Step
Action
Information
1
Turn off the BLM500.
Use the mains power ON/OFF
switch. See Figure 3 on page 4.
2
Disconnect the BLM500 from the
mains power supply.
3
Clean the static elimination bar in
the connecting bridge.
• Open the connecting bridge
cover.
• Clean the pins on the bottom of
the static elimination bar with a
small brush.
4
Clean the static elimination bar in
the gathering area.
• Open the gathering area cover.
• Clean the pins on the bottom of
the static elimination bar with a
small brush.
5
Close the BLM500
• Close the gathering area cover.
• Close the connecting bridge
cover.
6
Connect the mains power supply.
7
Turn ON the BLM500.
