6 - Maintenance - Install New Stitch-wire
60
Océ BLM500 User Manual
Fit a New Stitch-wire Spool
Install the Stitch-wire into the Stitch Head
Step
Action
Information
1
Open the stitch-wire cabinet.
2
Remove the stitch-wire cap and
finished stitch-wire spool.
3
Fit a new stitch-wire spool.
4
Fit the stitch-wire cap.
5
Loosen the end of the stitch-wire
from the edge of the stitch-wire
spool.
6
Use wire-cutters to remove the
damaged end of the stitch-wire.
Remove enough stitch-wire to
leave the end of the stitch-wire
clean and straight.
7
Feed the stitch-wire through the
stitch-wire guide.
8
Install the stitch-wire.
See “Install the Stitch-wire into the
Stitch Head” on page 60.
Step
Action
Information
1
Pull the stitch-wire from the end of
the stitch-wire guide.
2
Make sure the stitch-wire runs
behind the gas-strut.
Pull stitch-wire in direction of arrow
