Power and Control
34
Plockmatic PowerSquare™ 224 - Service Training Workbook
Identify the components: (use the list below)
900-208 Main Control PCB
Anti-Static Power Unit Fuse &
Relay PCB Fuse Holder
Interlock Relay PCB
Inverter
Low Voltage Transformer Assy
Mains Power Input Connector
Mains Power On and Off Switch
Power Interface PCB
Shuttle Motor Interface PCB
Terminal Block
Toroidal Transformer
User Interface (GUI) - Operator Menu
Plockmatic PowerSquare™ 224 - Service Training Workbook
15
Perform the following tasks:
Set the PSQ to make a preset size book:
A3 input size
Measure the paper from the ream
Enter the measured size into the touch screen
40 sheets (4mm thick)
2 stitches
Save as “A3 Test”
Set the PSQ to make a non-standard book:
A4 input size
Measure the paper from the ream
Enter the measured size into the touch screen
35 sheets (3.5mm thick)
3 stitches, with custom stitch pitch
4 forms, with +5 pressure
Trim to 130mm
Save as “A4 Test”
Re-reference all axes. Observe what happens on the message list.
Open the gathering area, then use
HELP
to find out about the error
message on the GUI message list.
CONFIGURE
MACHINE OPTIONS
MEASUREMENT
STITCH SENSOR
PRESET PAPER
SIZES
SIDE TRIM (P2T)
PBS INSTALLED
Select mm or inches as units
Turn stitch sensor on or off
ISO ‘A’ sizes or US sizes
Touch to turn off communication to
the Side-Trimmer. Only do this if the
Side-Trimmer is disconnected.
Touch to turn off communication to
the Book Stacker. Only do this if the
Book Stacker is disconnected.
NETWORK SETTINGS
(service function)
FORM SETUP
(service function)
SHUTTLE
(service function)
MENU
ACCESS LEVEL
Operator, Supervisor, Service
(Distributor & Factory)
CURRENT LANGUAGE
AXES
Re-reference individual axes
BRIDGE
Reference individual axes
COUNTERS
RESET
Book / Sheet / Stitch
Resets the operator count
Window
Buttons
