Watlow D4T Data Logger
•
34
•
Chapter 2 Configuration Using Composer
Configuring the TFTP Transfer:
1. Because there are several TFTP servers available note that naming may be different. What
is most important from the server standpoint is that the appropriate IP bindings are set
while the security allows for read/write capability as shown below.
2. Navigate back to the section entitled
and follow the procedure to de-
fine what it is to be captured within the file. Within this same procedure (step 5), it will
be important to define the IP address of the remote computer while also determining
whether the file will be transferred manually or automatically.
3. Start the TFTP server and then start data logging by pushing the following buttons on the
D4T front panel:
Main Menu > Data Logging > Start
If the file does not seem to be transferring as expected check out the parameter identified
above as
and the table that follows it for some assistance.
